Diverging Lat Pulldown Assembly Guide: Assembling the Equipment
7
Attaching the Movement Arm Assembly
CAUTION: At least two people are required to position the parts of this
equipment successfully. Do not attempt to assemble the equipment by
yourself.
Note:
Do not tighten fasteners until instructed to do so.
To attach the movement arms to the equipment:
1.
Remove the bolt and washers from each side of the movement arm
assembly set them aside.
Figure 7: Movement arm fastener removal
2.
Ask your assistant to position the movement arm onto the movement
frame as shown in the following figure. Attach the movement arm using
the fasteners removed in step 1. Using a
³₈
-inch hex tip, tighten each bolt
to 500 in-lb (56 N-m). Repeat this procedure to attach to the other
movement arm.
Figure 8: Attaching the movement arms
3.
Locate the two end caps in the bag that ships with your equipment. Insert
an end cap into each movement arm assembly and press it into place.
Figure 9: End cap attachment
Содержание Discovery DSL0314
