Diverging Lat Pulldown Assembly Guide: Assembling the Equipment
4
Attaching the Weight Tower to the
Movement Frame
Note:
Do not tighten fasteners until instructed to do so.
Have your assistant hold the movement frame in an upright, balanced position
while you complete the following procedure.
To attach the weight tower to the movement frame:
1.
Locate the point where the cross support attaches to the movement frame.
Using a
⁵₁₆
-inch hex bit, remove the two bolts, two lock washers, and two
flat washers installed there and set them aside.
Note:
The nuts are already attached to the transition plate.
Figure 2: Cross support attachment to movement frame
2.
Locate the point where the base support attaches to the movement frame.
Note:
Depending on the type of equipment you are assembling, the
connector plate may be located on the base support or on the movement
frame.
Using a
⁵₁₆
-inch hex bit, remove the two bolts, two lock washers, and two
flat washers installed there and set them aside.
Figure 3: Connector plate locations based on equipment type
Содержание Discovery DSL0314
