Helios Large Display Analog Input Batch Controller Instruction Manual
PD2-6210
10
Safety Information
Caution
:
Read complete instructions
prior to installation and operation of the
controller.
Warning
:
Risk of electric shock or
personal injury.
Warning!
Hazardous voltages exist within enclosure.
Installation and service should be performed only by trained
service personnel.
Installation
There is no need to open the clear plastic front cover in order to complete the installation, wiring,
and setup of the controller. All programming is done through the buttons and switches located
under the lower door panel and are accessible by removing the single securing screw. Wires
should be run through the knockout holes located on the bottom of the controller.
There are a total of four pre-drilled conduit entry holes located at the bottom of the controller. If
the need to drill additional holes arises, make sure you will have the clearance necessary for
conduit mounting hardware.
Do not disconnect the RJ45 connector found on the right side of the controller wiring board. Doing
so will disable the onboard digital I/O, RS-485 serial communications, and M-Link functionality.
Instructions are provided for changing the transmitter power supply to output 5 or 10 VDC instead
of 24 VDC, see page 12.
Unpacking
Remove the controller from box. Inspect the packaging and contents for damage. Report
damages, if any, to the carrier. If any part is missing or the controller malfunctions, please contact
your supplier or the factory for assistance.
!
www.calcert.com
1.888.610.7664
0
5
10
15
20
25
30
