P
RO
V
U
™ PD6363 Dual Analog Input Rate/Totalizer
Instruction Manual
47
Totalizer Count Up/Down (
Count
)
The totalizer count up/down menu may be used to program the total and grand total to either count up from 0 when
reset or count down from a programmed value when reset. Total and grand total may have their countdown numbers
programmed individually from 0 to 999999.
Analog Output Programming
(
AoutPr
)
The
Analog Output Programming
menu is used to
program the behavior of the 4-20 mA outputs. The
following parameters and functions are programmed
in this menu for each analog output:
1. Source: Source for generating the 4-20 mA
output
2. Overrange: Analog output value with display in
overrange condition
3.
Underrange: Analog output value with display in
underrange condition
4. Max: Maximum analog output value allowed
regardless of input
5. Min: Minimum analog output value allowed
regardless of input
Analog Output Source
The analog output source can be based on either of
the input channel rate, total, or grand totals (Ch-A,
Ch-B), the math channel (Ch-C), maximum stored
value of either input channel (Hi-A, Hi-B), minimum
stored value of either input channel (Lo-A, Lo-B),
maximum or minimum of A and B (Hi-AB, Lo-AB),
relay set points, or the Modbus input.
To base an analog output on the rate, total, or grand
total of channels A or B, select the channel in the
Analog Output Source
menu. Then select the rate,
total, or grand total as the source reference for the
output, and program the output scale.
