powersoft Ottocanali HGT Series, Руководство по обслуживанию

Страница: 12 / 24

12
OTTOCANALI HGT | SERVICE MANUAL
INDEX
7. Disassembling the 8CHHGT/STD/FRONT
In order to disassble the front panel, remove both air filter
covers as portrayed on (Fig. 9).
These are held in place by a powerful magnet and no tool
is required during this operation.
By means of a 2mm Hex head screwdriver, remove the 4
screws highlighted on (Fig. 10).
It is now possible to remove the front led cover. (Fig. 11)
Use the 2mm Hex head screwdriver to remove the screw
that holds the magnet in place.
Use a M6 socketed screwdriver to remove the 4 bolts
highlighted on (Fig. 12).
It is now possible to gently remove the FRONT board.
Pro tip: dump the filters in a mild soap and water solution,
then rinse them out and dry them thoroughly.
If deemed necessary, replace the filters referring to the
repair kit list located at the end of this manual.
Fig. 9
Fig. 10
Fig. 11
Fig. 12