Te
ch N
ot
e’
s
N
umbe
r
Keep This Technical Note For Future Reference
1 Preliminary consideration
This article is related to the following products:
f
DigiMod IS Series
f
All DigiMod modules with DSP-C installed
2 Tools needed
f
Phillips cross-wing screwdriver
f
Flathead screwdriver
f
A pair of pliers for electrical uses
f
One XLR male connector
f
Two Phoenix 5 poles connector
f
One audio cable
3 Procedure
Disconnect the 3 micro-match connectors from the DSP-C.
Take the Phillips screwdriver to remove the 2 screws from the
DSP-C.
Take the flathead screwdriver and push out the DSP-C from
the sim board.
With the aid of the pliers add the 2 jumpers on the pins BY22-
BY32 in the CN18 connector and pins BY31-BY21 on the CN17
connector.
TECHNICAL NOTE #16 rev. 01
Removing DSP-C from DigiMod
How to remove the DSP-C card from Digimod amp modules
FIGURE 1: Disconnecting the micro-match connectors
FIGURE 2: Removing screws from the DSP-C
FIGURE 3: Jumpers on DigiMod, overview
FIGURE 4: Removing the DSP-C
FIGURE 5: Jumpers on DigiMod, detail
FIGURE 6: Jumpers in place
© 2012 - 2013 Powersoft
powersoft_TN016_RemoveDSPC_en_v1.0
