Powersmart PSSHD24T, Инструкция по эксплуатации

Страница: 14 / 79

14
standard pins or fasteners. Damage may occur to the snow blower and drive systems.
NOTICE: Never replace the shear pins with standard pins or fasteners. Damage may occur to the snow
blower and drive systems.
TROUBLESHOOTING
Problem Causes Remedy
WARNING - Before attempting to make any inspections, repairs or adjustments, stop the engine, wait for all moving parts to
stop moving and carefully disconnect the engine spark plug wire. If tipping or
turning the snow blower is required for any inspection or repair, first wait until the engine is cool to the touch and then drain the
engine of all fuel and oil into suitable containers and store or dispose of in a
proper manner.
Engine Systems - Note: For all engine problems, see the below troubleshooting information.
Engine Fails to
Start
(Engine cranks
over)
Spark plug wire disconnected Connect wire to spark plug
Faulty spark plug Clean, adjust gap, or replace spark plug.
Engine flooded with fuel
Discontinue choke or primer use, clean or replace spark
plug.
Safety key not inserted in engine ignition Insert key fully into the switch
Choke not in START position
Move choke to START position, after engine starts
slowly move to RUN position as engine speed and
operation stabilizes at the set rpm. If engine still does not
start move to half choke and crank engine.
Fuel incorrect, old or stale, will not ignite
Empty and clean fuel tank & carburetor, refill with fresh,
clean gasoline. (Note: Fuel may become stale after 30
days in some cases)
Blocked or clogged fuel system or line Clean fuel system or line
Extension cord is not properly attached to electric
starter terminal Re-insert extension cord into electric starter terminal.
Engine electric
starter
will not crank
engine
No power from power supply, tripped breaker Check power supply extension cord is attached to.
Extension cord wire gauge is too small, or cord
is too long Use proper rated and length extension cord
CHOKE in ON or partial ON position Move CHOKE lever to RUN
Engine runs
erratic,
stalls or seems
low on
power
Fuel incorrect, old or stale
Empty and clean fuel tank & carburetor, refill with
fresh, clean gasoline. (Note: Fuel may become stale
after
30 days in some cases)
Blocked or clogged fuel system or line Clean fuel system or line
Carburetor is in need of cleaning Clean fuel system and carburetor
Spark plug wire loose Connect and tighten spark plug wire
Faulty spark plug Clean, adjust gap, or replace spark plug, see Engine
Operator's manual
Engine oil over filled
Drain oil to proper level. Oil should not be above the
top 2 threads of LOWER fill plug.
Engine oil level low or empty Add oil
Drive system
No forward or
reverse drive
movement when
drive handle
Drive belt loose or damaged Check drive belt tension pulley for damage or
incorrect tension, repair as necessary. Replace drive
belt.
Friction drive wheel is worn or damaged Replace friction drive wheel