Powersmart DB7004, Инструкция по эксплуатации

Страница: 12 / 34

12
ASSEMBLY AND ADJUSTMENTS
The following section describes steps necessary to prepare the snow thrower for use. If after reading this
section, you are unsure about how to perform any of the steps please call (800) 791-9458 Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the snow thrower or
shorten its life.
Unpacking
Unpack the snow thrower and all its parts, and compare against the list below.
1. Snow Thrower
2. Upper Handle with Discharge Chute Assembly
3. Crank Handle
4. One Pair of Skid Shoes with hardware
ASSEMBLY
Your Snow Thrower will require some assembly. Please complete the following steps before using your
Snow Thrower.
WARNING: This snow thrower is heavy. Assembly procedures may require lifting
equipment or two people.
Step 1 – Upper handle assembly
1. Attached the upper handle to the lower handle using (4) knobs,
washers and bolts.
Step 2 – Chute assembly
1.
Install the discharge chute onto the chute flange on the auger
housing. The chute only rests on the flange.
2.
Using provided 2 bolts and nuts (1) to lock chute direction support column (2) in position.
Knob, Washer and Bolt
2
1