Powerplus POWXG1018, Руководство пользователя

Страница: 20 / 22

POWXG1018
EN
Copyright © 2015 VARO
P a g e | 20
www.varo.com
14 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA 99
Acoustic power level LwA 115
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration) Max 11.8 m/s² K = 1,5 m/s²
15 STORING A CHAIN SAW
Caution : never store a chain saw for longer than 30 days without performing the following
procedures. Storing a chain saw for longer than 30 days requires storage maintenance.
Unless the storage instructions are followed, fuel remaining in the carburetor will evaporate,
leaving gum-like deposits. This could lead to difficult starting and result in costly repairs.

Remove the fuel tank cap slowly to release any pressure in tank. Carefully drain the fuel
tank.

Start the engine and let it run until the unit stops to remove fuel from carburetor.

Allow the engine to cool (approx. 5 minutes).

Using a spark plug wrench, remove the spark plug.

Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace spark plug. (Fig.19)
Note: store the unit in a dry place and away from possible sources of
ignition such as a furnace, gas hot water heater, gas dryer, etc.
Removing a unit from storage

Remove spark plug.

Pull starter rope briskly to clear excess oil from combustion chamber.

Clean and gap spark plug or install a new spark plug with proper gap.

Prepare unit for operation.

Fill fuel tank with proper fuel / oil mixture. See fuel and lubrication section
16 TROUBLE SHOOTING
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION
Unit won’t
start or
starts but
will not run.
Incorrect starting procedures.
Incorrect carburetor mixture
adjustment setting.
Fouled spark plug.
Empty fuel tank.
Primer bulb was not pressed
enough.
Follow instructions in the user manual.
Have carburetor adjusted by an
authorized service center.
Clean/gap or replace plug.
Fill fuel tank with properly mixed fuel.
Unit starts,
but engine
has low
power.
Fuel filter is plugged.
Incorrect lever position.
Dirty spark arrestor screen.
Dirty air filter.
Incorrect carburetor mixture
adjustment setting service dealer. Replace the fuel filter.
Move to run position.
Replace spark arrestor screen.
Remove, clean and reinstall filter.
Have carburetor adjusted by an
authorized service center.