POWX720
EN
Copyright © 2021 VARO
P a g e
|
6
www.varo.com
8.3
Using the laser level
8.3.1
Using the wall bracket
This is ideal for laying floor tiles.
Screw the magnetic screw completely into the housing.
Attach the marked 360°rotating base.
Attach the wall bracket with the bould to the 360° rotating base.
You can attach the wall bracket with laser level to the wall.
8.3.2
Using the tripod
The included Tripod allows the Laser Level to
be adjusted from 475mm from the floor to
approx. 1240mm when completely extended.
This is ideal for hanging pictures, wallpaper,
chair rail, windows, etc.
1.
To set up the Tripod Base, simply pull the legs outward. Secure the Tripod legs by
tightening the Center Pole Locking Collar. At its’ lowest setting, the Tripod raises the
Laser Level up to 475mm from the floor.
2.
Attach the Laser Level with the 360° rotating base attached to the Tripod by screwing it
on to the Tripod Neck.
3.
To extend the legs of the Tripod, release one or both clamps on each leg and lengthen
them by pulling to the desired height. Secure the legs in their expanded position by
closing the leg clamps. For additional extension, loosen the small black knob on the side
of the Tripod and turn the handle clockwise to raise the tripod neck. Secure the Tripod
Neck at the desired height by tightening the small black knob. At its highest setting the
Tripod raises the Laser Level to approx. 1240mm from the floor.
4.
Make sure the Tripod is set on relatively level surface. If the surface is extremely uneven,
adjust the tripod legs and the screws on the laser level base to create a relatively level
surface.
Note: The Self-Leveling Feature will compensate for ±6°
