POWX225
EN
Copyright © 2019 VARO
P a g e
|
8
www.varo.com
Warning! Do not use saw blades made of high-speed steel.
▪
Put the push stick or push block into its storage when not in use.
▪
Use a push stick or push block to feed the workpiece past the saw blade.
Warning! Do not use the saw for rebating or grooving.
Warning! Do not use the saw for cutting inserts (grooves that end in the
workpiece).
▪
Use only saw blades whose maximum permissible speed is not less than the speed
indicated on the saw and is suitable for the material to be cut.
▪
When transporting the machine, use only transportation devices and never use guards for
handling or transportation.
▪
During transportation, make sure that the upper part of the saw blade is covered; for
example, by a protective hood.
7 GUIDELINES FOR USING EXTENSION CORDS
▪
Make sure the extension cord is in good condition. When using an extension cord, be sure
to use one that is heavy enough to carry the current that your product will draw. An
undersized cord will cause a drop in line voltage, which will result in loss of power and
overheating.
▪
Make sure your extension cord is properly wired and in good condition. Always replace a
damaged extension cord, or have it repaired by a qualified person before using it. Protect
your extension cords from sharp objects, excessive heat, and damp or wet areas.
▪
Before connecting the motor to the power line, make sure the switch is in the OFF position
and the electric current is rated the same as the current stamped on the motor nameplate.
Running at a lower voltage will damage the motor.
This tool must be grounded while in use in order to protect the operator
from electric shock.
8 ASSEMBLY
8.1
Rip fence (fig. 1)
▪
Lift the rip fence handle (a) until the rear holding clamp (b) is fully extended.
▪
Place the rip fence on the saw table, lowering the rear of the fence onto the table first.
▪
Push down the rip fence handle (a) in order to lock the rip fence in position.
8.2
Installing the blade (fig 2)
Warning! Disconnect the mains supply and wear safety gloves.
▪
Disassemble the saw blade guard (6).
▪
Remove the table insert (5).
▪
Loosen the nut by placing the open-ended spanner on the nut and countering with another
open-ended spanner on the flange.
Warning! Turn the nut in the rotational direction of the saw blade.
