POWX093
EN
Copyright © 2015 VARO
P a g e
|
7
www.varo.com
7.3
Dust extraction outlet
You are advised to use the dust extraction outlet. You can purchase
a suitable commercial vacuum cleaner or extract the dust via an
extractor tube while the cutting machine is in operation. The outlet
must project out of the rear of the machine (5). Two bolts and nuts
are supplied to attach it.
Hold the extractor outlet in position and lay the cutting machine on its side. Push the long bolt
through the machine base until it projects at the fastening point for the extractor outlet (6).
Place the nut in the hexagon-shaped recess (7). Tighten the bolt with a suitable wrench and
moderate force until the outlet is securely attached. Repeat the procedure at the other side.
CAUTION: Dust may cause respiratory problems. Certain laminated board
materials are carcinogenic. After work, always remove all dust from the
machine.
7.4
Assembly of parallel stop
Locate the parallel stop and the guide rods. Push the guide rods into the casting and secure
them with the adjusting screws (8). Inspect the machine base and the four securing points.
Loosen the locking screws and push the guide rods into the machine base (9). The parallel
stop is continuously adjustable and permits various parallel cuts.
