POWX07568TX
EN
Copyright © 2016 VARO
P a g e
|
8
www.varo.com
9.3
Clamping the work piece
Make sure the work piece can’t be catapulted. The clamp(12) is the most perfect gadget to
avoid this.
Press the work piece against the fence (4) and between the clamp
Tighten the clamp (12) clockwise to secure the work piece.
9.4
Horizontal mitre angle
The horizontal mitre angle can be set in the range from -45° to 45°. The horizontal mitre angle
scale shows the currently set in degrees.
Pull up the turn table lock release lever (11) to make the turn table (5) free.
Loosen the locking knob (6) at the top of the guide rail.
Push the lever (6).
Rotate the saw table (5) to the required angle ( to the right or to the left). The required
angle can be read of the scale flute (8).
Tighten the locking knob (6) clockwise.
When you have moved the grip for turning table (6) to the position where the mitre angle
pointer points to the desired angle on the mitre angle scale, release the turn table lock
release lever.
9.5
Adjusting of the cutting angle (Fig. 1)
Position the saw in the lower position and block it with the blocking pin.
Now hold the try square (90°) against the guide rail and the saw blade. The latter must
make complete contact with the try square. If this is not the case, then you can adjust the
angle by loosening the counter nut and adjust with adjustment bolts until the angle
between the blade and the turn table equals 90°.
To carry out this step, use the delivered key for loosening the screws. Do not forget to re-
tighten the screws afterwards.
9.6
Vertical bevel angle
The vertical bevel angle can be set in the rang of 0° to 45°. The vertical bevel scale shows the
currently set in degrees.
Loosen the locking lever(22), if tightened.
Swing the tool arm with the handle to the required angle.
Tighten the locking lever (22).
9.7
Slide lock adjustment
To unlock and lock the slide bar (14), turn the slide bar lock knob (23) counterclockwise or
clockwise
9.8
Switching ON / OFF
For your safety use both hands to switch the power tool on and off.
Connect the power tool to the power supply.
Pull the on/off switch (16) in the direction of the handle. The saw blade rotates as long as
you keep the switch engaged.
When you want to turn off the machine, you have to release the on/off switch (16).
9.9
Laser (13)
Your machine is equipped with a laser.
The For long workpieces you should use the slide; loosen the locking knob for this purpose.
Saw trough the work piece.
Switch off the power tool.
Wait until the saw blade (2) has come to a complete standstill before removing the work
piece.
