POWX07558T
EN
Copyright © 2018 VARO
P a g e
|
9
www.varo.com
▪
Saw trough the work piece.
▪
Switch off the power tool.
▪
Wait until the saw blade (2) has come to a complete standstill before removing the work
piece.
9.8
Switching ON / OFF
For your safety use both hands to switch the power tool on and off.
▪
Connect the power tool to the power supply.
▪
Pull the on/off switch (15) in the direction of the handle for about 2 seconds to reach its
max. speed. The saw blade rotates as long as you keep the switch engaged.
▪
When you want to turn off the machine, you have to release the on/off switch (15).
9.9
Laser (23)
Your machine is equipped with a laser, switch on the On/Off switch for the laser light
.
9.10
Dust bag
To attach the dust bag (18), fit it onto the dust extraction adapter. When the dust bag is about
half full, remove the dust bag from the tool and empty it.
9.11
Sawing
Make sure the saw
blade doesn’t block while you are sawing. It causes
damage to and burning of the motor. If there is a blockade of the saw blade,
please loosen the switch immediately to prevent damage at the motor.
▪
Clamp the work piece firmly.
▪
Set the required horizontal mitre angle or the required vertical bevel angle.
▪
Switch on the power tool.
▪
Move the handle (14) slowly downwards. You have to push the safety switch (16) before
you can do this.
9.12
Sawing special work pieces
Curved or round work pieces need to be secured against slipping.
Make sure there is no gap between the work piece and the fence (4) or the saw table (5).
9.13
Replacing the saw blade
Disconnect the tool from the outlet before working on the saw blade.
Wait a while before touching the saw blade. It can be very hot.
The teeth of the saw blade are very sharp.
▪
Pull the mitre saw downwards and lock it in the lowest position by pushing the retaining
pin.
▪
Remove the front mounting screw from the protective hood
▪
Turn the centre cover and raise the blade guard.
▪
Press the spindle lock.
▪
Then remove the screw, outer flange and blade.
▪
Replace the saw blade (the tips of the sawing teeth have to point in the same direction as
indicated by the arrow on the cover) and then reassemble all parts in the reverse order.
