POWX07557T
EN
Copyright © 2016 VARO
P a g e
|
10
www.varo.com
Pull the mitre saw downwards and lock it in the lowest position by pushing the retaining
pin.
Remove the front mounting screw from the protective hood
Turn the centre cover and raise the blade guard.
Press the spindle lock.
Then remove the screw, outer flange and blade.
Replace the saw blade (the tips of the sawing teeth have to point in the same direction as
indicated by the arrow on the cover) and then resassemble all parts in the reverse order.
Turn the plastic cover back in its original position and mount the front mounting screw from
the protective hood.
When replacing the saw blade, you can tighten the slide bar with the
locking knob (23).
10 CLEANING AND MAINTENANCE
Before performing any work on the equipment, pull the power plug.
10.1
Cleaning
Regularly clean the machine housing with a soft cloth, preferably after each use.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Make sure no water can reach the inside of the power tool!
10.2
Connecting cable
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).
11 TECHNICAL DATA
Nominal Voltage
220-240V ~ 50 Hz
Power rating
2200 W
No load speed
4800 min-1
Protection class
II
Blade size
210 mm x 30 mm x 2.4mm
Weight
19 kg
12 CUTTING CAPACITY
Worktable tilting
angle
Head tilting angle
Height x width (mm)
90°
90°
65 x 260 mm
45°
90°
65 x 170 mm
90°
45°
35 x 260 mm
45°
45°
35 x 170 mm
