POWX07551T
EN
Copyright © 2016 VARO
P a g e
|
9
www.varo.com
8.8
Removing and installing the table insert (Fig. 7)
NOTE: The mitre saw comes with the table inserts already installed. These
instructions are for replacing or adjusting either insert side.
WARNING! To avoid injury: 1) Always unplug the saw to avoid accidental
starting. Remove all small pieces of material from the table cavity before
performing any cuts. The table insert may be removed for this purpose, but
always reattach the table insert prior to performing a cutting operation. 2)
Do not start the sliding compound mitre saw without checking for
interference between the blade and table insert. Damage could result to the
blade, table insert or turntable if blade strike occurs during the cutting
operation.
To remove, loosen and remove the six screws (1) on the table insert (2) with a Phillips
screwdriver and remove the insert.
To install, reposition the table insert, install the six screws and tighten.
Check for blade clearance by moving the slide carriage through the full motion of the blade
in the table slot. If neither side of the insert hits the saw blade, loosen the three screws for
that side and adjust. Tighten the screws and check again for blade clearance.
8.9
Mounting the mitre saw (Fig. 8 ,9, 10)
WARNING! To avoid injury from unexpected saw movement: 1) Disconnect
the power cord from the outlet and lock the cutting head in the lower
position using the stop latch. 2) Lock the slide carriage in place by
tightening the slide carriage lock knob. 3) To avoid back injury, lift the saw
by using the hand holds for transportation. Bend with your knees, not your
back. 4) Never carry the mitre saw by the power cord or by the switch
handle. Carrying the tool by the power cord could cause damage to the
insulation or the wire connections resulting in electric shock or fire. 5) To
avoid injury from flying debris, do not allow visitors to stand near the saw
during any cutting operations.
Mounting instructions:
For stationary use, place the saw in the desired location, directly on a workbench where
there is room for handling and proper support of the workpiece. The base of the saw has
four mounting holes (10 - Fig. 8). Bolt the base of the mitre saw (1) to the work surface (5),
using the recommended fastening method as shown in Fig. 9.
1. Mitre saw base
2. Hex head bolt
3. Rubber washer
4. Flat washer
5. Work surface
6. Flat washer
7. Lockwasher
8. Hex/Lock nut
9. Jam nut
NOTE: Mounting hardware is not included with this tool. Bolts, nuts,
washers and screws must be purchased separately.
For portable use, place the saw on a 3/4 in. thick piece of plywood. Bolt the base of the
mitre saw securely to the plywood using the mounting holes (10 - Fig. 8) on the base. Use
C-clamps to clamp this mounting board to a stable work surface at the worksite. (Fig. 10)
NOTE: If the mitre saw stand is used, please mount it as shown in FIG. B.
