POW162X
EN
Copyright © 2015 VARO
P a g e
|
6
www.varo.com
After ending the work, always switch the machine off before removing the plug from the
socket.
8
DEPTH CONTROL
2 adjustment options:
8.1
Using the graded scale: (Fig. 5)
Loosen the collet of the depth regulator (9).
Remove the clamp handle (11) and push the machine downwards until it touches the work
piece (11).
Tighten the clamp handle again.
Use the graded scale (12) to adjust to the desired depth (10).
Tighten the collet.
8.2
Using the depth regulator revolver:
2 different depths can be quickly adjusted. This is done using the 3 adjustment screws that are
on the depth regulator.
9
STARTING AND STOPPING (FIG. A)
To start, press the on/off button (1). Adjust speed with the adjusting key (13).
To stop, press the same button on “O”.
Warning: plastic parts should be routed at low speeds! After use, put the
machine away only after it has come to a complete halt. Do not store in a
dusty place; the dust might enter and disrupt the mechanical parts.
10 MAINTENANCE
If you want to examine the machine, always remove the plug from the socket. The machine
has been designed to function perfectly with a minimum of maintenance.
Keeping the machine dust-free and clean will increase its lifespan.
10.1
Cleaning
Regularly with a damp cloth, preferably after every use.
The ventilation plates must always be free of dust. A damp cloth and detergent can be used
for stubborn dirt, but never ammonia, alcohol, gasoline or other caustic products because
these will damage the plastic parts.
10.2
Lubricating
This machine does not need additional lubrication.
10.3
Defect
In case of defects resulting from wear and tear to a part, contact the store where you bought
the machine. In the back, you will find a list with the reference numbers of the various parts.
