POWPG40140
EN
Copyright © 2019 VARO
P a g e
|
7
www.varo.com
8 ASSEMBLY
8.1
Bike handle installation (Fig. 1)
Install the U-handle on the fixing holder, install the clamp and fasten with the screws.
8.2
Installation protection guard (Fig. 2)
▪
Remove the 2 screws from the guard.
▪
Position the guard so it can be fixed into place with the clamp and the screws.
▪
Tighten the screws
8.3
Installing the harness (Fig. 3)
▪
Adjust the harness hanger in a comfortable position
▪
Buckle the harness at the hanger
8.4
Replace the metal blade to spool
CAUTION: NEVER use unit if blade is warped or has teeth that are chipped or
missing. Replace a damaged blade immediately.
CAUTION: Always wear heavy-duty work gloves when handling and installing
a blade.
8.4.1
Disassembly metal blade
▪
Align the hole on the gear box to the slot on the flange washer
▪
Use the screwdriver to go through the hole and slot, and hold the flange washer
▪
Loose the nut and remove the metal blade and cup washer
8.4.2
Assembly spool
(
Included)
▪
Install the spool and tighten it.
8.4.3
Assembly spool (POWACG1051)
(Fig.4a+b)
▪
Add the lower plate (C) before you screw the spool (D) into the output Axle of part A
▪
Install the spool and tighten it.
STOP ENGINE IMMEDIATELY!
Excessive vibration of blade means that it is not properly installed-stop engine
immediately and check blade. Blade not properly installed will cause injury.
9 FUEL AND LUBRICATION
9.1
Fuel
Use regular grade unleaded petrol mixed with 40:1 custom 2-cycle engine oil for best results.
Use mixing ratios in Section FUEL MIXING TABLE below.
WARNING: Never use normal petrol in your unit. This will cause permanent
engine damage and void the manufacturer’s warranty for the product. Never
use a fuel mixture that has been stored for over 90 days.
WARNING: 2-cycle lubricant must be a premium grade oil for 2-cycle air cooled
engines mixed at a 40:1 ratio. Do not use any 2-cycle oil product with a
