Powerplus 166914, Руководство пользователя

Страница: 8 / 16

POWX07583
EN
Copyright © 2021 VARO
P a g e | 8
www.varo.com
9 SPECIAL PRODUCT CHARACTERISTICS

Quick change-over between cross-cut and table saw mode.

45° sawing range for beveling. (45° left)

90° sawing range for bevelling (45° left or 45° right) with five preset stops

Perfectly suited for mobile use, due to its low weight and small dimensions

TCT saw blade

Installation of additional guides possible

After an interruption of the power supply, a restart protection prevents that the machine
starts up again when the power supply is restored.
10 INSTALLATION AND TRANSPORT
Do not carry the machine on the handgrip; the handgrip is not designed to
carry the full weight of the machine. For carrying the machine, hold it on
both edges of the base (12).
10.1 Installation

Get help from another person for lifting the machine out of the box.

Turn the turntable into the 90° position and tighten up the mitre locks.
Note: If the machine must be mounted on a workbench, then the rubber feet should NOT be
installed.
You run the risk of injury, if you handle the machine incorrectly when lifting
or turning it. Always hold the machine firmly by the base (12).

Position the machine on a suitable surface:

All 4 feet must rest firmly on the surface.

The ideal height of the surface is approximately 800 mm.

The saw must stand firmly in position, even when larger workpieces are being sawn.

You can keep the packaging for future use, or you can dispose of it separately, based on
the type of material, and it in an environmentally friendly manner.
10.2 Transport

Push the table saw downwards and at the same time pull out the locking knob (22) to lift
the table saw upwards.

Position the lower saw blade guard (14) over the saw guide piece (21) and push
backwards until you hear a click, and until the lower saw blade guard is positioned at the
black line on the saw guide piece.

Lower the saw head by pushing in the safety lock (6) and activate the locking pin (22).

Position the mitre guide (4) over the lower saw blade guard and fasten it.

Lift the machine up by grasping both sides of the base (12).
Note:

The essential operating components of the machine are presented in this section.

Make sure to read this section, before you use the machine for the first time.