Copyright© 2011, Fieldstone Products Inc. Fieldstone Products Inc. reserves the right to make changes in the product at any time,
without notification.
pamx-pm3-manual 19 October 2015
AC to DC Converter/Charger
AC to DC
CONVERTER/CHARGER
PM3 models 15, 35, 45, 55, 60, 75, and 100 Amp
with 3 Stage Charging
Installation & Maintenance
SAFETY ALERT
FOR YOUR SAFETY, READ ALL INSTRUCTIONS BEFORE INSTALLATION AND OPERATION.
INSTALLER:
Provide these instructions to the end user or consumer.
CONSUMER:
Keep these instructions for future reference.
NOTICE: Products are not to be used nor are warranted in aerospace, medical or life safety applications.
WARNING – Avoid Possible Injury or Death
120 VAC
is present. This Converter/Charger is designed to convert
120 VAC
to
12 VDC
. It also provides low voltage
power for charging on-board
12 VDC
batteries. The Converter/Charger is a “
switch mode
” type and is designed to be
maintenance-free with no user serviceable components. The Converter/Charger power output is “
current limiting
” by
design.
WARNING – Avoid Personal Injury or Product Damage
NEVER store electrical devices in compartments where flammable liquids (such as gasoline) exist.
DO NOT mount/install unit in compartments designed for storage of batteries of flammable liquids.
1.
DISCONNECT DC POWER.
Disconnect the battery POS (+) wire at the battery end before connecting this Converter/Charger
to any vehicle/device wiring.
2.
LOCATION.
The mounting location may be on any interior (out of direct weather) surface. Location chosen must be accessible
after installation. When mounted inside a cabinet, the cabinet must be large enough to allow dissipation of heated air. Make
sure that there is a minimum of 1” (one inch) free air space at each end of the unit so that cooling air can move through the unit
properly. AVOID foreign contaminants such as dirt, metal particles or moisture.
3.
MOUNTING.
Flanges with holes are provided for ease of mounting using standard fasteners. Confirm that the surface that the
converter/charger is mounted to is solid and will hold the weight (up to10 lbs) during vehicle operation.
