Wiring
6.
Wiring
1.
Before you start
o
Wiring should be done as discreetly as possible
o
It is required to use
16gage
DC wires at the minimum
o
Wires may not ‘jump’ from two surfaces (i.e. counters) if there is a gap between
surfaces, wiring should run down the leg of one counter, along the baseboard or
underneath the chair rail, and then up the leg of the next counter.
o
It is recommended to use wire channels in order to protect the wires
o
All movable tables should use a tether box (See design guidelines)
o
Wire channels should either be in a horizontal or vertical direction until hitting
either the tile base at the bottom of the wall or the chair rail, whichever is closer.
Do not run wire channeling in anything other than a vertical or horizontal
direction.
o
When running AC power from a floor outlet to the underside of a community
table, a black floor plate and black conduit should run up the leg of the table to a
junction box mounted on the underside of the table
o
The junction box will split and run AC power to the power strips and DC power to
a power supply that will be wired to the Charging Spots
o
Loose wires should be replaced with conduit on underside of table
Important note:
When working with power take necessary percussions to avoid safety
hazards