PowerLand PD210E, Руководство пользователя, Страница: 19 / 36

15
STARTING THE ENGINE/STOPPING THE ENGINE
Starting the Engine
1. Make sure that the AC circuit breaker is in the OFF position, and that there are no welding cables
attached to the DC terminals. The generator may be hard to start if a load is connected.
2. Turn the fuel valve lever to the ON position.
3. Pull the choke rod to the CLOSE position.
4. Make sure the auto-throttle switch is in the OFF position, or more time will be required for
warm-up.
5. Move the engine switch to the ON position.
6. Pull the starter grip lightly until resistance is felt, then pull briskly.
NOTICE:
Do not allow the starter grip to snap back against the engine. Return it gently to prevent
damage to the starter or housing.
7. Push the choke rod to the OPEN position as the engine warms up.
8. If you wish to use the auto-throttle system, turn the auto-throttle switch to the AUTO position after
the engine has warmed up for 2 or 3 minutes.
Stopping the Engine
In an emergency:
1. To stop the engine in an emergency, move the engine switch to the OFF position.
In normal use:
1. Turn off any AC electrical appliance.
2. Move the engine switch to the OFF position.
3. Turn the fuel valve lever to the OFF position.