background image

 

Climate Control Simplex

 Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product 
described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in 
personal injury and/or property damage! Retain instructions for future reference.

 Powerex • 150 Production Drive • Harrison, OH  45030 • USA
1-888-769-7979 • www.powerexinc.com

IN259604AV 1/14

Description

The AS Series Powerex Simplex Air Compressors have been 
designed, broken-in and tested to meet the most demanding 
specifi cations in the pneumatic climate control industry for 
low oil carryover and long life.

All Powerex air compressors have reliable operation and 
feature high quality construction and components. An 
unloading feature is included on all compressors to provide 
loadless starting. Oil entrainment is minimized by the use of 
lap joint piston rings, low compressor speeds and a special 
lubricating oil with a high fl ash point and low carbon 
content.

Powerex compressor motors are NEMA Class B design. Single-
phase motors have built-in overload protection and a DPST 
disconnect switch. Three-phase motors require a manual or 
magnetic starter and three overload heater coils which may 
be ordered as a factory mounted and wired option.

 Safety Guidelines

This manual contains information that is very important 
to know and understand. This information is provided for 
SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help 
recognize this information, observe the following symbols.

 

Danger indicates an imminently 

  hazardous situation which, if 

not avoided, WILL result in death or serious injury.

 

Warning indicates a potentially  

  hazardous situation which, if 

not avoided, COULD result in death or serious injury.

 

Caution indicates a potentially 

  minor or moderate injury.

 

Notice indicates important 

  information, that if not 

followed, may cause damage to equipment.

NOTE:

 Information that requires special attention.

CALIFORNIA PROPOSITION 65

 

This product or its power cord 

  may contain chemicals known 

to the State of California to cause cancer and birth defects or 
other reproductive harm. Wash hands after handling.

Specifi cations

Product

AS Series Powerex Simplex Air Compressors

Performance 
Specifi cations

See Page 2

Lubrication

Splash Lubrication System

Operating 
Voltages

1Ø 

115 - 280 / 230 Volts, 60 Hz

3Ø 

280 - 230 / 460 Volts, 60 Hz

Compression 
Cycle

Single-Stage

Motor 
Overload 
Protection

1Ø 

Built-in Thermal Overload (Standard)

3Ø 

Magnetic Starter and Three Thermal 

 

Overload Switches (Optional)

Pressure 
Settings

Cut-In: Factory Set at Approximately 70 psig (490 kPa)
Cut-Out: Factory Set at Approximately 90 psig (630 kPa)

Overpressure 
Protection

ASME Safety Valve Factory Set and Sealed at 
Approximately 115 psig (805 kPa)

Outlet Air 
Connections

3/4 inch NPT (30, 60, and 80 Gallon Tanks)

Tank Sizes

30 Gallon to 80 Gallon

California 
Ordinance 
462 (L) (2)

Meets Requirements of this Ordinance

Tank Isolation

Standard All Units

The performance specifi cations are nominal and conform to acceptable industry standards. For application at conditions beyond these 
specifi cations, consult the local Powerex offi ce. Powerex shall not be liable for damages resulting from misapplication or misuse of its products.

Содержание AS Series









Отзывы: