1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
6.4
INSTALL THE BIT
1. Push reversing button in the center position to lock
the switch trigger.
2. Open or close the chuck jaws to a point.
3. Lift the front of the machine to keep the bit from
falling out of the chuck jaws.
4. Put the bit into the point.
5. Tighten the chuck jaws.
NOTE
Turn the chuck body to close the chuck jaws. Do not
use a wrench to tighten or loosen the chuck jaws.
WARNING
Put the bit straight into the chuck jaws. Do not put the
bit into the chuck jaws at an angle then tighten.
6.5
REMOVE THE BIT
1. Push reversing button in the center position to lock
the switch trigger.
2. Open the chuck jaws.
3. Remove the drill bit.
WARNING
Be prepared for binding at bit breakthrough. When
these situations occur, drill has a tendency to grab and
kick opposite to the direction of rotation and could
cause loss of control when breaking through material.
If not prepared, this loss of control can result in
possible serious injury.
7
OPERATION
WARNING
Always wear eye protection.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
7.1
START THE MACHINE
O
I
NOTE
The machine can not work until the reversing button is
pushed fully to the left or right. Do not operate the
machine at low speeds for extended periods of time.
1. Push the switch trigger to turn the machine ON (I).
7.2
STOP THE MACHINE
1. Release the switch trigge to turn the machine OFF
(O).
WARNING
Release the switch trigger and let the coupler to come
to a complete stop.
7.3
ADJUST THE VARIABLE SPEED
A
B
1. Increase the trigger pressure to make a higher
speed.
2. Decrease the trigger pressure to make a lower
speed.
7
English
EN