Power works CAF809, Руководство оператора, Страница: 4 / 19

1. Connect the plug of charger (2) to an AC power outlet.
2. Put the battery pack (1) into the charger (2).
1
3
2
This is a diagnostic charger. The Charger LED Light (3)
illuminates in a specified order to show the current battery
status. They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING
RED
OFF
FULLY CHARGED
RED
GREEN
BLINKING
BATTERY IS TOO
WARM (REMOVE FOR
APPROX. 30 MINUTES TO
ALLOW TO COOL)
RED GREEN
NO BATTERY PRESENT
RED
BLINKING
OFF
DEFECTIVE BATTERY
(REMOVE AND REPLACE
WITH A NEW BATTERY)
RED
BLINKING
GREEN
BLINKING
Incorrect Defect Note:
1. Put the battery pack into the charger.
• If the status LED1 flashes red and LED2 flashes
green, remove the battery pack from the charger for 1
minute.
2. Put the battery pack into the charger again.
• If the status LEDs show correct, the battery pack is
good.
• If the status LED1 and LED2 stay blinking, remove
the battery pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
• If the status LEDs show correct, the battery pack is
good.
• If the statusLED1 and LED2 stay blinking, the
battery pack is defective and it is necessary to replace
the battery pack.
4.2 EXAMINE THE CHARGER
If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move
the charger and battery pack to a location where the
temperature is between 6° C to 40° C (42.8° F to 104°
F) .
WARNING
If you attempt to charge the battery pack in a warm or hot
environment, and the charger LED light is red, remove the
battery pack and let the battery cool for approximately 30
minutes.
4.3 MOUNT THE CHARGER
1. Get the location of the wall to attach the charger.
2. Use 2 wood screws to attach the charger on the wood
studs.
3. Drill two paralleled holes 5 3/4” (14.5cm) on center.
4. Use wall anchors and screws to attach the charger to the
drywall.
NOTE
If you do not use the battery pack and charger for a long
time, please remove the battery from the charger and pull
out the AC power plug.
5 MAINTENANCE
5.1 CLEAN THE MACHINE
NOTE
Keep the air vent free of blockage, saw dust, and wood dust.
Do not spray, wash, or submerge in water.
• Clear the unwanted material out of the air vent with a
vacuum.
• Clean housing and the plastic components with a soft, dry
cloth.
5
English
EN