Power Sentry EAC ISSM 375 SM Скачать руководство пользователя страница 1

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed, including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

 1. 

DO NOT USE OUTDOORS.

  2.  Do not mount near gas or electric heaters.
  3.  Do not use this equipment for other than its intended use.
  4.  The 

EAC ISSM 375 SM should be mounted securely and in locations and at heights where it will not readily 

be subjected to tampering by unauthorized personnel.

  5.  The use of accessory equipment and replacement parts not recommended by the original manufacturer 

may cause an unsafe condition and void the warranty.

  6.  The AC voltage rating of this equipment is specified on the product label. Do not connect the 

 

EAC ISSM 375 SM equipment to any other voltage.

  7.  Use only the battery part number specified for use with the 

EAC ISSM 375 SM. Failure to do so may cause 

an unsafe condition, will void warranty, and result in non-compliance with UL specifications.

 8.  The 

EAC ISSM 375 SM uses a sealed valve regulated lead acid battery. Batteries can be punctured if not 

handled properly, therefore use caution when servicing batteries.  In the event battery acid comes in contact 

with eyes or skin, flush with fresh water and consult a physician immediately.

 9.   Install in accordance with the National Electrical Code and local regulations.
10.  Installation and servicing should be performed by qualified personnel.
11.   Electricians and end-users need to ensure product system compatibility before final installation.

SAVE THESE INSTRUCTIONS

THIS UNIT CONTAINS A 

RECHARGEABLE VALVE-REGULATED  

LEAD ACID BATTERY. PLEASE 

RECYCLE OR DISPOSE OF 

PROPERLY.

INSTRUCTION MANUAL

INTERRUPTIBLE AC INVERTER SYSTEM

MODEL EAC ISSM 375 SM

FOR EMERGENCY LIGHTING POWER

Содержание EAC ISSM 375 SM

Страница 1: ... the battery part number specified for use with the EAC ISSM 375 SM Failure to do so may cause an unsafe condition will void warranty and result in non compliance with UL specifications 8 The EAC ISSM 375 SM uses a sealed valve regulated lead acid battery Batteries can be punctured if not handled properly therefore use caution when servicing batteries In the event battery acid comes in contact wit...

Страница 2: ...Figure 1 INSTALLATION INSTRUCTIONS CAUTION Before installing make certain the A C power is off NOTE The battery is shipped in separate packaging for ease of handling Store the battery in a cool dry and safe location until ready for installation The battery may be kept in storage for up to 3 months without recharging CAUTION This is a dual input and output voltage unit It can be connected to either...

Страница 3: ...oads Application Notes are available on the internet or through Customer Service 4 CONNECTING THE INTERNAL CIRCUIT BREAKER A Two leads are provided for connection to the internal circuit breaker Select the proper voltage lead VIOLET for 120VAC or YELLOW for 277VAC and connect it to the circuit breaker Cap the unused lead Push the circuit breaker switch to the closed position so that the indicator ...

Страница 4: ... emergency fixtures will extinguish The equipment is supplied with an automatic solid state charger designed to fully recharge the battery within 72 hours after AC power is restored and then maintain the battery in a fully charged state Allow the battery to charge for a minimum of 72 hours after installation or power failure before conducting a 90 minute discharge test The Life Safety Code and the...

Отзывы: