Power Products GUARDIAN S6-ATS, Инструкция по эксплуатации

Страница: 87 / 154

84
Englis
h
1.3 Remote control stop
1 Push
STOP button in the controller.
2 Turn the key ignition to ON position
3 Close the gasoline valve.
10.4 Restart receiver of remote control
When we change the key ignition to "ON", the remote receiver installed in the
machine starts operation and keep awaiting the start signal of controller. This
receiver has a small power consumption, it is supplied from the generator battery.
In the case that the generator stay for several days with the remote receiver
activated, the battery would eventually discharged. To prevent severe
dischargued of the battery, generator has installed an automatic disconnection of
the remote receiver. When the generator with the key to ON (active remote
receiver) stay more than 12 hours of inactivity, the remote receiver is turned off
automatically. In this case the start by remote controlers not work. If you want to
reactivate the remote system simply press the "RESTART RECEIVER" button on
the control panel.
NOTE: Unless it is an emergency never interrupt, in any way, the startup
process. If the generator started mistakenly let maneuvers in process finish before
giving a new order with the control.
NOTE: The remote receiver has a small electric consumption of about
20mA while is activated. Generator cut this consumption after 12 hours
without use, anyway we suggest pass key ignition to OFF when you finish
the use of generator.
NOTE: A severe discharge of the battery could lead to irreversible damages in
it. Damages in the battery will not be covered by the warranty.
10.5 Synchronizing new controllers
1. Turn the key ignition to ON position.
1. Press one time RESTART RECEIVER button.
2. Press and keep press RESET button place in control panel, until PILOT
LAMP in panel lights.
4.
Press the “
START
” button in controller, the
PILOT LAMP in control panel
will flash, then press again once the START button, the generator start the
star up process and the new controller is synchronizing.
10.6 Totally remote system restore
If the remote start up system fails or works abnormally
.
1 Turn the key ignition to ON position and press RESTART RECEIVER button.