POWX1751
EN
Copyright © 2018 VARO
P a g e
|
8
www.varo.com
As soon as the tank pressure is built up, the motor switches off
automatically.
The motor switches automatically on as soon as the tank pressure
becomes too low.
8.4
Safety valve
The safety valve has been set for the highest permitted pressure of the pressure vessel. It is
prohibited to adjust the safety valve or remove its seal
Actuate the safety valve from time to time to ensure that it works when required. Therefore you
need to remove the protection cover.
9 PNEUMATIC CHISEL/HAMMER SET
9.1
Appliance
Ideal for general cutting, chipping and scraping.
9.2
Loading and operation (Fig. 6)
WARNING: Ensure you read, understand and apply safety instructions
before use.
1.
Connect the tool to the air hose.
2.
Press the trigger to operate the tool.
3.
The flow of air may be regulated by adjusting flow valve at the base of the handle.
4.
Ensure the air supply is clean and does not exceed 90psi while operating the tool. Too
high an air pressure and unclean air will shorten the product life due to excessive wear,
and may be dangerous causing damage or personal injury.
If a filter/regulator/lubricator is not installed on the air system, air operated
tools should be lubricated at least once a day or after 2 hours work with 2 to
6 drops of oil, depending on the work environment, directly through the
male fitting in the tool housing.
10 BLOW GUN
Use
Method of use
Recommended
Pressure
Blowing
Connect the compressed air supply to fitting. Press the
trigger and direct the jet over the surface to be blown.
Adjust the pressure
according to need
WARNING! Wear eye protection! Air blast can cause debris and dust to be
blown back towards you.
