Page 23 of 89
(PVI-6000-OUTD-xx-AU Rev:1.0)
3.4.
Wall mounting
AURORA should be mounted in a vertical position as shown in fig.6.
The package includes a hardware kit with 3 6.3x70 steel screws and 3 SX10 wall
plugs for installation of metal bracket to a masonry wall. Screws and wall plugs
can be installed using 3 of the 5 holes available on the bracket (ref. part C).
WARNING
: Bracket shall be mounted vertically on wall: spring side
shall face up, while side with M6 PEM shall face down.
Mounting holes for wall mounting should be 8 mm in diameter and min. 70 mm
deep.
For wall of other construction materials, it is the installer's responsibility to provide
suitable mounting hardware. We recommend using stainless steel screws.
Hang AURORA on the spring at the bracket top, by means of the metal mount
fastened to the upper part at inverter back. The central part of this plate features a
seat for fastening the spring (Part A).
Once inverter top end is secured in place, you need to secure its bottom end.
From inverter front, use an M6x10 screw and washer to secure the unit to bracket
PEM, starting the screw in its thread through lower plate centre slot.
FRONT
BACK
Part.A
Part.B
Содержание AURORA PVI-6000-OUTD-AU Series
