Power Fist 8843708, Руководство пользователя

Страница: 11 / 36

V1.0 3/16 in. Air Riveter 8843708
Visit www.princessauto.com for more information 11
7. Lightly oil the jaws and place the jaw assembly back into position.
Screw the jaw carrier into place. Tighten with both wrenches
8. Check and adjust the stroke length (see Adjusting the Stroke Length).
9. Fit the outer cylinder back onto the air riveter and tighten.
O-RING REPLACEMENTS
Replacement O-rings (#15 and 47) are included for the connections between
the front and rear sections of the riveter and between the handle and air
cylinder. Refer to the Parts Breakdown for the exact location.
CLEANING
1. Clean with a soft cloth and mild detergent. Do not use solvents for
general cleaning.
2. Deposits may accumulate in the tool’s air inlet. Clean the air inlet and
flush the tool with a suitable gum solvent. You may need to
disassemble the tool for cleaning. Dry thoroughly before reassembly.
3. Continuing tool impairment after cleaning may indicate worn or
damage components. Repair the tool or have a certified technician
repair it for you.
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other lubricants are not
suitable and will damage the tool or cause a malfunction during use.
NOTICE! Never use a penetrating oil to lubricate an air tool. Penetrating oil
acts as a solvent that will dissolve the tool’s grease packing and may
damage the o-rings, causing the tool to seize or malfunction.
1. All air tools have an internal coating of grease to prevent corrosion
during shipping and storage. Remove this grease by adding a generous
amount of air tool oil in the air inlet and then run the tool under no
load until the exhaust is clear.
2. Manually add a drop or two of air tool oil into the tool’s male connector
before each use and after every hour of continuous use. The tool will
not work properly without lubrication and parts will wear prematurely.
3. Avoid adding too much air tool oil as this can cause premature power
loss and eventual tool failure. A qualified technician will need to take
the tool apart and clean out the excess oil.
4. Apply a generous amount of air tool oil to the tool before storing it for
an extended period of time (overnight, weekend, etc.). Run the tool for
approximately 30 seconds to ensure the oil is evenly distributed
throughout the tool. Store it in a clean and dry location.