Power Fist 8655888, Руководство пользователя

Страница: 5 / 16

V4.0 Fender Roller Tool 8655888
Visit www.princessauto.com for more information 5
OPERATION
Letter references in parenthesis (A) refer to the included Identification Key.
The fender roller tool fits onto a 4 or 5-hole wheel hub. The diameter of the
tool’s holes range from 90 to 120 mm and fits most vehicle hubs.
1. Lift the vehicle up with a hoist or wheel jack. Place the vehicle on jack
stands if using a jack.
a. Consult the manuals for the jack, jack stands, hoist and vehicle for
safety instructions.
2. Remove the wheel and set aside. Keep the wheel lugs on hand.
3. Rotate the telescopic cantilever (C) to one side, until it cannot move any
farther. Position the tool over the wheel’s bolts so the arm’s 180º rotation
will cover the work area of the fender.
4. Place the conical washers on each bolt. Screw the wheel lugs onto the
bolts and tighten to secure the tool in place (Fig. 1 and 2).
5. Loosen the tommy screw (B) holding the flange roller (A) (Fig. 3).
6. Adjust the telescopic cantilever (C) by turning the handle (E). This will
adjust the cantilever’s position until it is the correct length (Fig. 4).
7. Secure the cantilever in place with the hand wheel (F).
Fig. 1 Fig. 2
Fig. 3
Fig. 4