V4.0
7.5A Rotary Hammer
8532251
Visit www.princessauto.com for more information
7
POWER CORD
1. Insert the power cord plug directly to the power supply whenever possible.
Use extension cords or surge protectors only when the tool's power cord
cannot reach a power supply from the work area.
a. When operating a tool outside, use an outdoor extension cord marked
W-A or W. These cords are rated for outdoor use and reduce the risk
of electric shock.
b. Use in conjunction with a Ground Fault Circuit Interrupter (GFCI). It is
recommended that the GFCI should have a rated residual current of
30 mA or less.
2. Do not operate this tool if the power cord is frayed, damaged or poorly
spliced, as an electric shock may occur, resulting in personal injury or
property damage.
a. Inspect the tool's power cord for cracks, fraying or other faults in the
insulation or plug before each use.
b. Discontinue use if a power cord feels more than comfortably warm
while operating the tool.
3. Keep all connections dry and off the ground to reduce the risk of electric
shock. Do not touch the plug with wet hands.
4. Prevent damage to the power cord by observing the following:
a. Do not pull on the cord to disconnect the plug from an outlet.
b. Keep the cord away from heat, oil, sharp edges or moving parts.
c. Never use the cord to carry the tool.
d. Place the electrical cord in a position that prevents it from coming into
contact with the tool and getting caught by the workpiece. The cord
should always stay behind the tool.
5. Do not allow people, mobile equipment or vehicles to pass over
unprotected power cords.
a. Position power cords away from traffic areas.
b. Place cords in reinforced conduits or place planks on either side of
the power cord to create a protective trench.
