User Manual
8490542
High Output Butane Torch
V 3.0
INTRODUCTION
With easy operation and Piezo automatic ignition, the torch can
reach up to 1300°C with an adjustable flame utilizing precise
flame control. The torch can be used for soldering, plumbing,
welding, culinary and more providing up to 60 minutes of burn
time when fully fueled
IMPORTANT SAFETY PRECAUTIONS
WARNING! The warnings, cautions and instructions discussed
in this instruction manual cannot cover all possible conditions
and situations that may occur. Common sense and caution
are factors that cannot be built into this product, but must be
supplied by the operator.
1.
Protect your eyes from sparks and light rays and
use heat resistant gloves while watching for sparks
in cuffs.
2.
Keep sparks and flame away from combustibles.
3.
Work in a well ventilated area.
4.
Do not work with damaged equipment. Never test
for leaks with an open flame.
5.
Always have a fire extinguisher handy.
6.
This product is not a toy; keep the unit away
from children.
7.
Ensure the flame is completely extinguished after
each use and always be sure that the unit is cool
before storing.
8.
Do not expose the unit to temperatures greater
than 49°C (120°F), or prolonged exposure
to sunlight.
REFUELING
1.
Ensure the OFF button (see figure 5) is in the off
position before filling.
2.
Turn the unit upside down and firmly push the
butane can into the filling valve (see figure 1). The
tank will take a few seconds to fill.
NOTE: Please allow a few minutes after filling for the gas
to stabilize.
OPERATION
CAUTION! The torch flame is almost invisible in daylight or in
strong light.
1.
Turn the gas adjustment wheel approximately
halfway between the “+” and the “-“ position (see
figure 2).
2.
Press in the child resistant unlock button on the
side of the torch (see figure 3). With the button
depressed, push the ignition button on the back of
the unit forward with your thumb (see figure 4).
You may see the blue flame immediately.
CAUTION! Always ignite away from people,
animals, or clothing.
3.
You may now remove your thumb from the
ignition button for hands free use and the flame
will keep burning until you press the OFF button
located on the front of the unit (see figure 5).
4.
The flame size may be adjusted with the gas
adjustment wheel by moving the wheel towards
the “+” symbol on the unit for more flame or
moving the wheel towards the “-“ symbol for less
flame (see figure 2).
5.
To turn the unit off, simply push the OFF button
located on the front of the unit all the way back to
stop the gas flow (see figure 5).
DISPOSING OF THE TOOL
If your tool has become damaged beyond repair, do not throw it
out. Take it to the appropriate recycling facility.
