Power Electronics SD 300 Series, Руководство по началу работы

Страница: 189 / 354

POWER ELECTRONICS SD300
DESCRIPTION OF PROGRAMMING PARAMETERS
187
Screen Description
Default
value
Range Function
Set on
RUN
CM.93 NAK frames 0 0 to 65535 Count the number frames received
with timeout.
YES
CM.94
[31]
Communications
update
N
NO
SI
This parameter enables sending the
current drive data configuration to the
communications card.
NO
CM.95
P2P
communication
selection
Disable
All
0 to 3
P2P communication allows sharing
input devices between different drives.
To enable it, RS485 communication
must be active.
This parameter allows defining which
devices will be master and which slave
in the P2P communication.
OPT. FUNCTION
0 Disable All
1 P2P Master
2 P2P Slave
3 M-KPD Ready
NO
CM.96
[32]
Digital output
selection
NO 000 to 111
When multi-function outputs are used,
a drive configured as P2P slave can
choose whether to use its own output
or the drive’s output.
OPT. FUNCTION
001 Analog output
010 Multi-function relay
100 Multi-function output
YES
[31] Only shown if an optional communications card has been connected.
[32] Displayed when AP.1 is set to 2 (Proc PID).