Power Electronics NB CITY, Руководство по аппаратному обеспечению и установке

Страница: 9 / 48

POWER ELECTRONICS NB City
SAFETY INSTRUCTIONS
7
EN
SAFETY INSTRUCTIONS
IMPORTANT!
Read carefully all documentation before manipulating the equipment and pay special attention to safety
recommendations to maximize the performance of this product and to ensure its safe use and installation.
It is the installer’s responsibility to follow the instructions provided on this manual, to follow good electrical
practices and to identify all mentioned warnings and recommendations before starting up and operating
the inverter.
WARNING
FIRST CONSIDERATIONS
The operations detailed in this manual may only be carried out by qualified personnel.
Qualified personnel referred to in this manual shall be applied to those who satisfy all safety standards,
regulations and laws applicable to the installation and operation of this equipment.
Read and keep the Hardware and Installation Manual for future reference.
Read all instructions and cautionary markings before installing the charger. Failure to follow these
warnings can result in serious electrical shock or even death. Pay attention at all times to prevent possible
accidents.
Ensure compliance with all safety regulations in force at the place where the charger is installed
in relation to both Medium and Low Voltage operations.
Otherwise, you could get an electric shock.
The electric vehicle charging system is in danger of ELECTRICAL DISCHARGE if the warnings in
this manual are not followed. Make sure the charger is completely isolated and de-energized
before handling or servicing.
To avoid electrical hazards, disconnect the input supply, ground the
equipment, remove control voltages before performing any tasks, and ensure that busbars are completely
discharged. Warning and safety labels must be properly affixed to terminals, cabinets and control panels
in accordance with local regulations.
When working on electrical installations, always remember to apply the FIVE GOLDEN RULES :
1. Visible shutdown of all live sources.
2. Mechanical locking of all cutting elements.
3. Verify the absence of voltage by using the appropriate tools for the voltage of the installation.
4. Ground and short-circuit all possible voltage sources.
5. Delimit and mark the work area.
Do not modify the equipment. If modified, Power Electronics will not assume any liability, and the
warranty will be voided.