Power Electronics NB CITY, Руководство по аппаратному обеспечению и установке

Страница: 17 / 48

POWER ELECTRONICS NB City
INTRODUCTION
15
EN
Charging process
The following sequence presents the process to be followed by the user for use in a loading session:
1. If the user management has not yet been configured and the charger is available, connect the hose
to the vehicle to start charging automatically and go to point 4.
2. If user management has been configured and the charger is available, activate the charging session
from the mobile application or RFID contact.
3. If the session has been validated, connect the charger to the vehicle using the appropriate hose.
4. Make sure that the connector has been interlocked.
5. If the session and communication between the charger and the vehicle are established correctly,
the charging will start.
6. Stop charging. The charging can be stopped in different ways: because it has reached 100% and
it stops automatically, by means of the mobile application, RFID contact or by stopping the load
from the vehicle itself.
7. Once the charging has stopped, the connector can be released.
Advanced charge functionalities
Smart fleet management
This functionality has been designed to minimize the initial investment and operation costs.
It is able to balance the power based on the number of charging posts in use. Therefore, the total power
required to supply the total energy gets substantially reduced, representing a cost reduction in the
electrical facility infrastructure and a cost saving due to a minor power contracted. Besides, the
hardware and the back-office communication is optimized.
Dynamic power control
This functionality is an option, it ensures dynamic adaptation of the power being used to charge the
vehicle in accordance with the energy being consumed by other electrical circuit, without having to
increase contractual power capacity