power automation PA 8000 EL, Руководство по установке, Страница: 73 / 108

5 Installation
WARNING!
Danger of injury due to improper installation and
commissioning!
Improper installation and commissioning can result in
severe personal injury or material damage.
n Prior to beginning installation, ensure that there is sufficient
space to work.
n Handle open sharp-edged components with care.
n Make sure that the assembly location is clean and well organ-
ized. Components that are loosely stacked or lying around can
cause accidents.
n Assemble components properly.
n Secure components so that they cannot fall or tip over.
5.1 Prerequisites and preparations
5.1.1 General requirements
Prerequisites for installation are influenced by the con-
trol unit's required operating conditions and must also
take into account the machine to be controlled.
– Ensure that the control unit's operating condition
requirements are met.
For further information see
Ä
Chapter 4.3 “Operating conditions” on page 66.
– Ensure that the operating conditions requirements
of the machine to be connected to the control unit
are met.
For further information see the CNC machine's
manuals.
Electronic components (e.g. mainboards, power sup-
plies, hard disks) have to be adjusted to the ambient
air temperature before using. The components must
not put to power until their temperature is the same as
the ambient temperature.
Safety
PA 8000 EL CNC control unit
Installation
24.09.2015 | 73