EN
operaTion
2200_EN-Einsatz_2740
- 23 -
3. Aligning the indicators
Requirement:
The raking height is set equally for both rotors
Align the height indicator (6) on both rotor units.
a. Open hose clip (7) underneath the rotor unit
b. Align the height indicator arrow (6) with the one on
the other rotor unit.
c. Re-tighten hose clip (7).
6
7
Adjust feeler wheels
1. Adjust the inner feeler wheel height using the
tensioning screws (TS).
The rotor should be inclined slightly towards the swath
to ensure clean raking. The tines on the opposite side
to the swath should be approx. 10-15 mm higher than
on the swath-facing side.
. Set the inner feeler wheel height so that the front tines
are at the same height in the direction of travel as those
on the opposite side to the swath.
The factory setting for the tensioning screws (TS):
approx. 230 mm from centre bolt to centre bolt.
TS
2. Adjust the outer feeler wheel height using the
spring pin (3) (Optional equipment)
The outer feeler wheel height must be adapted to any
change made to the raking height.
Set the feeler wheel height so that it sits lightly on the
ground.
3. Distance of the outer feeler wheel
NOTE
Risk of material damage Collision of the feeler wheel
with the tractor.
•
If the distance (A) of the front, outer feeler
wheel is changed, it could lead to a collision
with the tractor.
The distance (A) of the front, outer feeler wheel to the
tine rotor is fixed and must not be changed. Measure the
distance (A) from the spar inside edge to the centre of
the fastening bolt. Distance (A) is 405 mm. There must
be no visible, drilled holes in the feeler wheel carrier.
3
A
Setting the distance of the outer feeler
wheel
1. Loosen both clamps (1, 2).
2. Push the stop over the desired anchor (3, 4, 5)
3. Tighten both clamps (torque)
1
2
3
4
5
