EN
operaTion
2200_EN-Einsatz_2740
- 20 -
From working position to headland
position
075-09-10
1. Swivel the rotor arms to the headland position by moving
control unit 1 (single-acting) to "Raise".
Operate control unit 1 until the height no longer changes.
(If the headland height is not appropriate see "Setting
headland height")
Settings on rotor chassis
Requirements:
- level and firm ground
- 1.5 bar pressure in all tyres
- The machine is attached to the tractor and in the working
position
1. Set cross slope
The rotor chassis should be slightly inclined to
the swath side to ensure clean rake work. The side
rake start should be approx. 1.0-1.5 cm higher.
1. lower the rotor unit using the crank handle
(1) until the inner tines just touch the ground.
TIP
After adjustment, secure the crank (1) using the
retaining clip.
1
2. Set the outer tines to approx. 1.0 - 1.5 cm above
the ground.
TIP
All wheels (a, b, c) can be adjusted using
the eccentric screw.
a1
b1
b2
c
a2
With the TOP 962 C, the double feeler wheel
(C) can be adjusted using an adjusting
spindle.
a1
b1
b2
c
a2
Equally adjust the wheels which are located
on one side of the rotor unit (a1 and a2 and/
or b1 and b2).
a. Eccentric screw system:
3
2
a1
b1
b2
c
a2
