- 8 -
1800-Gb ApplicAtion_3751
EN
2. Lifting gear with cross beam
On lifting gear with a crosspiece (Q) between the lower
links, damage could occur to the drive shaft when
lowering the attached implement.
In order to prevent damage an extra elevator unit is to
be installed between the Weiste-triangle and the lifting
gear.
In a case such as this please contact our Customer
Service Dept.
3. PTO shafts are very far forward
When towing implements whose p.t.o stub is positioned
a long way forward, the drive shaft must be shortened
quite a bit.
Safety advice
CAUTION
Risk slight or moderate injury to double-acting
tractors Front linkage
•
Do not exceed the maximum lowering depth
of the mower unit! This results in inadmissi-
bly high pressure on the boundary chains,
which can burst. In the most unpleasant
case, this will result in injuries to persons in
the danger area around the mower.
Attaching in general
1. Observe safety tips in supplement A.
2. Mark off the implement at the tractor's front lifting gear.
3. •Secure locking bolts with linch pins.
PTO shaft guarding
The cardan shaft is to be checked before first use and
adapted if necessary (see Chapter "Adapting the cardan
shaft" in Attachment B.
#
Attaching problems
1. No front hydraulic connection:
If the tractor has no hydraulic connection at the front,
then a hydraulic hose must be run from the rear to the
front.
A switch between the front lifting gear (HW) and front
control device (SG) via a three-way tap may be necessary
with some tractors.
HW
SG
attaching to tractor
