- 36 -
1800_GB-General maintenance_BA
EN
Parking in the open
Clean and protect the piston rods with grease prior to longer
periods parked out in the open
FETT
TD
49
/93/2
Cleaning of machine parts
Be advised! Do not use high-pressure cleaners for the
cleaning of bearing and hydraulic parts.
- Danger of rust!
- After cleaning, lubricate the machine according to the
lubrication plan and carry out a brief test run.
- Cleaning pressure being too high may damage the
paint.
Safety advice
DANGER
Life-threatening danger exists through moving or
rotating parts
Carry out maintenance works on the machine only
when:
•
It has been parked securely on level, firm
ground.
•
It has been secured against rolling with
wheel chocks.
•
The tractor engine is turned off and the pto
shaft is stationary.
•
All moving or rotating parts (especially the
mowing disks) have come to a halt. (Hearing
test!)
•
The tractor's ignition key has been removed.
•
If necessary, remove the cardan shaft.
Life-threatening danger exists when under the
machine.
•
Support the sub-areas you are under in an
adequate way.
WARNING
Risk of serious injury through escaping oil.
•
Pay attention to scuffed or clamped hose
areas.
•
Clean the couplings of the oil hoses and the
oil sockets prior to each connection!
•
Wear the relevant protective clothing.
NOTE
Material damage due to impurities that have
penetrated into the hydraulic system
•
Clean the couplings of the oil hoses and the
oil sockets prior to each connection!
General maintenance information
Please observe the information below to maintain the
machine in good condition even after a long period in
operation:
- Re-tighten all bolts after the first hours in operation.
The following should be checked in particular:
Blade bolt connections on the mowers
Tine bolt connections on the rake and tedder
Winter storage
- Clean machine thoroughly prior to winter storage.
- Park protected against the weather.
- Change or top up gear oil.
- Protect exposed parts from rust.
- Lubricate all greasing points.
- Disconnect terminal, store dry and protected from frost.
Spare parts
a. Genuine parts and accessories are specially designed
for the machines.
b. We expressly draw your attention to the fact that genuine
parts and accessories not supplied by us, have not been
tested and approved by us.
c. Under certain circumstances, the installation and/or
use of such products may negatively modify or impair
the specified structural properties of the machine. The
manufacturer accepts no liability for any damage caused
through the use of non-genuine parts and accessories.
d. Any unauthorised modifications and/or fitting of
components and attachments to the machine negates
any liability on the part of the manufacturer.
general maintenance