EN
CONTrOL
2101_EN_Steuerung_2310
- 35 -
Notes:
The following notice-windows will appear during operation
to tell you that the function you have selected is currently
unavailable. Simultaneously, these notices also contain
instructions on how to make these functions available.
Symbol
Explanation
Action: Use the red control unit
to raise the machine.
Situations:
1. You press the transport key,
but the machine is in the
working position.
2. You press the transport key
and the machine is in the
headland position.
3. You press the transport
key, the machine is in the
working position but there
is insufficient pressure in
the hydraulic system.
Action: Use the red control unit
to lower the machine.
Situations:
1. You press the transport key,
the machine is in transport
position and the pressure in
the hydraulic system is OK.
Action: Set the red control unit
to the float position to enable
ground adaptation.
Situations:
1. The unit is in working
position and you want to
start working.
2. You press one of the side
swath keys, the implement
is in headland position, the
belt halves are in the narrow
position.
Action: Use the green control
unit to increase the working
width.
Situations:
1. You press the overlift key
and the machine is in transport
position.
Action: Use the green control
unit to reduce the working width
to minimum.
Situation:
1. You press the transport key,
the machine is in the raised
transport position.
Action: Check that the swath
apron is retracted. After
retracting the swath apron,
acknowledge this message by
tapping on the green "tick" key.
Situation:
1. You press the transport
key, the machine is in the
headland position, the
swath apron is extended.
Action: Lower the machine to
normal ground clearance to be
able to travel in normal traffic
or to pass under obstacles
hanging higher than 4 metres.
Situation:
1. You are underway with
increased ground clearance
Action: Switch off the cardan
shaft drive.
Situation:
1. After folding into transport
position, the cardan shaft
is still turning.
Action: Preselect the desired
belt units.
Situation:
