GB
TransporT posITIon
0600_GB-TRANSPORTSTELLUNG_288
- -
• For safety reasons, turn off drive shaft and
wait for rotor to stop completely.
• Changing from working position to
transport position is only to be carried out
on even, firm ground.
1. Stopcock opened (position E).
2. Remove tine arms (1a) from both rotors.
Removal of tine arms (1a) should only be carried out
when necessary, e. g. to reduce implement's total
height.
• Place tine arms (1a) onto holding pins located on
carriage frame and secure with linch pin.
3. Swing guard rail inward, left and right, and
secure with spring pin.
4. Make sure that swivel area is free and that
nobody is standing in the danger area.
5. Raise both rotor units slightly.
• Use single action servo-valve (ST) for this.
6. Bringing outer rotor into the narrowest
operating position.
This step should only be carried out if necessary, e.g.
to reduce implement's total height.
7. Swinging both rotor units into the transport
position (H2).
• Use the single action servo-valve (ST) for this.
Attention!
Check whether the locking hooks (10)
are locked into position correctly.
8. Swivel protection pipe (10) backward
(pos. T).
The protection pipe (10) in the transport position.
9. Close stop cock (position A)
TD 50/96/10
a
T
10
a
e
TD44/4/8
ST
TD33/7/8
10
10
TD 44/94/15
a2
a1
Conversion from working to transport position
Attention!
Changing from
working position
to transport
position is only to
be carried out on
even, firm ground.
