- 26 -
0700_GB-Beladen_563
GB
Safety tips:
•
Turn off
the drive motor
and take off the
drive shaft when
carrying out all
adjustment work.
•
Faults
in the Pick-up
area are to be
eliminated only
when the drive
motor has been
stopped.
•
Be
aware of crushing
points when
moving the Pick-
up down or up!
Adjusting the pick-up
1. Raise pick-up slightly and secure with adjusting struts
(51), left and right sides in same position.
2. Secure with linch pin.
High adjustment:
with tall stubble and
extremely uneven
ground.
Low Adjustment:
with short green fodder
and even ground.
Impact deflector adjustment (52)
- In low position (T) for small swaths and short fodder.
- In high position (H) for high swaths.
Loading process in general
Important tips:
• A transfer, which is located on the drawbar, tells which
p.t.o.-r.p.m. (540 rpm/1000 rpm) your trailer is equipped
for.
• Therefore take care that a drive shaft with the correct
overload safety is used (see spare parts list), so that no
unnecessary damage is caused to the trailer through
overloading.
• Always adapt driving speed to the surroundings.
• Avoid making sudden curves when driving through hills
and valleys, and when transversing slopes (danger of
tipping).
Loading green fodder
- As a rule green fodder is collected in swaths.
- Cut swaths collected are always stalk heads.
- Set deflector (52) low position (T).
Loading dry fodder
- Correct dry fodder collection is in swaths.
- Don’t make swaths too small in order to save loading
time.
- Set deflector (52) in the position (H).
Starting the loading process
1. Move control lever (43) for pick-up and conveyor
drive to "ON" position.
2. Switch on tractor’s p.t.o..
3. Lower pick-up.
Take care!
Doing this automatically switches on the
Pick-up and press
drive.
When switch lever
„4“ is in the „OFF“
p o s i t i o n t h e n
the Pick-up and
press will not be
activated.
4. When loading,
switch control unit (ST)
to "lower" or "float" and
in doing so the pick-up
regulates itself to the
uneven ground
(only
Select-Control)
.
So the pick-up regulates
itself to the uneven ground.
5. Observe p.t.o.-r.p.m.
• Load using average p.t.o.-r.p.m. (400-450 rpm).
To observe during the loading process!
• O n l y r a i s e
pick-up when
loading channel
is empty.
• When driving
through curves
reduce motor
r.p.m.
• When driving
through sharp
curves switch off p.t.o. and raise pick-up.
• Avoid uneven loads! Important because of possible
drawbar overloading (see details on the drawbar
concerning permitted support load).
• To optimumly fill the loading space, switch the scraper
floor on briefly (do not let it run continually).
• Observe the permitted axle load and total weight!
Finishing the loading process
1. Raise Pick-up.
Doing this automatically switches off the Pick-up and
conveyor drive.
2. Move the switch lever „43“ to the „OFF“ position.
This position is for your safety. Doing this prevents the
Pick-up and press from being unintentionally activated,
e.g. when lowering the Pick-up while the p.t.o. is
running.
loading The Trailer
