- 24 -
0500_GB-Schneidwerk_563
GB
cuTTer uniT
Secure the cutter beams against unintentional
swinging out
The screws (SK and SK4) prevent the cutter beams
from swinging out during operation
- Screw (SK4) for the upper cutter bar
- Screw (SK) for the lower cutter bar
Setting
- Loosen locking nut
- Turn the screw far enough to place light pressure
on the cutter beam
- Secure screw with locking nut
Set cutter beam vertically
- When the cutter frame is swung back in, the setting
should be such, that it enables the frame tubing to fit
into the opening on the moulded frame without any
difficulty (see sketch).
Adjustment on the underside of the cutter beam
- Firstly, adjust the height with screws (SK1)
- Then adjust horizontally with screws (SK2)
- Repeat procedure if necessary
125-04-29
Adjusting the cutter beam
Adjusting screws for lower cutter beam
- The catch hook (1) is adjusted with screws (SK5)
- The limit stop in the lower position of the cutter beam
is adjusted with (SK6)
