HUDSON CANOPY BED
Queen / King / Cal King
Pre-Assembly:
Please read all instructions carefully before assembly.
For your safety and ease, assembly by two people is recommended.
Carefully lay out and identify all parts and hardware prior to assembly.
Save all packing materials until assembly is complete to avoid accidentally discarding small parts or hardware.
Part Included:
BOX 1
BOX 2
BOX 3
BOX 4
•
(1) Headboard (A)
•
(1) Footboard (B)
•
(2) Side rails (C1, C2)
•
(1) Center Support Rail (D)
& Legs (3 short, 3 long)
•
(2) Slat Rolls
•
(2) Side canopies (E1, E2)
•
(2) Front & Back canopies (F1, F2)
Hardware Enclosed:
•
(64) Wood screws ¼ x 1” (includes 2 additional screws)
•
(4) Worktop
Connector
•
(1) Wrench
Key
•
(1) Allen
Wrench
Assembly instructions:
1. Attach side rails (C1, C2) to headboard (A) and footboard (B), placing hook into slot. (Fig. 1)
2. Place center support rail with three legs (D) into the brackets found at the center of headboard and footboard. (Fig. 2)
3. Lay the slat rolls in place so the pre-drilled holes on the end of each slat line up with the pre-drilled holes on the side
rail lip.
4. Secure the slats by inserting the wood screws. Tighten screws with a Phillips screwdriver. (Fig. 3)
5. Lay front, back (F1, F2) and side canopies (E1, E2) on a smooth and flat surface. Put all parts together using worktop
connectors and wrench key so that it becomes a fully assembled canopy. (Fig. 4).
NOTE: All canopy parts are lettered A, B, C, D. Make sure to attach each part to meet with another part of the same
letter; A to A, B to B, C to C, and D to D.
6. Carefully place the assembled canopy on top of each poster. Assembly is complete.
