Date: 3‐Apr‐15
www. potterybarn.com
Page 3 of 6
Rev:
Assembly Instruction Steps:
1. Using caution remove all components from their boxes making sure to set aside all hardware and parts.
2. To connect base with the TV Stand, Desk, Corner Cabinet/TV Stand or a separate base:
Set the base on the side of these units. Pull out the top two drawers and set them aside. Using the pilot holes as
a guide, bore holes on the side panels using a drill with the 5mm drill bit (c).
NOTE:
The pilot holes on side panel to be drilled through are countersink holes.
Do not
drill the shelf pin holes.
Only bore holes if this base is to be connected with other pieces in the Logan Collection.
3. Adjusting
the
levelers:
Due to an uneven floor, the furniture may not sit level due causing it to wobble. If the furniture wobbles, determine
which corner does not touch the ground correctly. With two people follow these steps:
1) Pull out the bottom drawer and adjust the levelers using the Allen key (d) on the interior holes of the bases
until adequate contact will be made with the floor. Gently set down the piece and check stability and door
alignment.
2) Repeat steps until furniture sits firmly and the holes on pieces to be connected are properly aligned.
Shelf pin hole.
NOTE: Pilot hole is
countersink hole.
