secure a screw at this mark directly into the wall and stud when instructed to do so below. Do not
use a provided anchor at this stud location because the
anchor cannot penetrate wood.
3)
For each mark that does not align with a stud, use a Phillips
screwdriver to install an anchor into the wall. To do this,
position the tip of the anchor against the wall at the mark and
then firmly push the anchor into the wall as you rotate it
clockwise. The anchor is designed to drive itself into the wall
as it is rotated. Continue rotating the anchor until the wide end becomes even with the surface of
the wall.
4)
With the help of another person, hold the item upright and against the wall so that the four through
holes align with either a stud-aligned mark or an installed anchor. Use a screwdriver to secure a
provided screw through each through hole and into the wall or an installed anchor. Rotate the
screw clockwise until tight.
5)
Installation complete!
Care Instructions:
To clean: Wipe with a soft, dry cloth.
Do not use any abrasive or strong-chemical household cleaners.
Thank you for your purchase
Stores | catalog | www.potterybarn.com
