PostProcess Technologies, Inc. • www.postprocess.com • REV A | page 38
The final
Agitation Configuration
setting
is called
Level 0
. When the DECI is in
Level 0, it means that there is no spray or
motion occurring. As shown at right, Level
0 can be set to be active for a percentage
of total
Run Time
or set with a
Duration
of minutes or a range of minutes. Level
0 can also be configured with a
Taper
setting so that the machine is not in a Level 0
state during the end of the cycle.
This completes the configuration for Level 1 Agitation. To repeat the configuration process for the
remaining levels, press the corresponding level button as shown at right. The Level 1 button is grayed out,
illustrating that Level 1 is the current level being configured. To advance to
Level 2
, press the number 2
button. To cancel out of the Agitation Configuration at any point, press the
“X”
button at the top of the
column. When finished, to save the configuration settings, press the
SAVE
(diskette) icon.
Setup
The second set of configuration settings is called
Setup
and refers to a variety of configuration for
everything from display settings, heat and pump settings, and more. To access the Setup Configurations,
press the
SETUP
button from the
Configuration
page.
Figure 35.
System Configuration
Screen
6. Appendix A
Figure 34.
Level 0
Screen
