BRX Power Injector Installation Guide
20
180-0192-001-R01
Step 2:
apply a sealing silicone to prevent water
infiltration through the opening of the rubber
grommet used for the cable binders with POTS
pairs.
Step 3:
apply a sealing silicone to prevent water
infiltration through the opening of the rubber
grommet used for the BRX Power Pairs.
Table 8: Applying a Silicon Sealant to the rubber grommets in use
3.6 Installing additional BRX-PWR- M Module(s)
When initially installing an 8-pair or 16-pair version of the BRX Power Injector, it is possible to install
one or two additional 8-pair BRX-PWR- M modules. The BRX-PWR-
M can be “hot” inserted. There
is no need to power down the BRX Power Injector.
Step 1:
The BRX Power Injector can house
three (3) BRX-PWR-M modules. Each BRX-
PWR-M provides power to 8 pairs. You can use
the available slots labeled as
Module 2 (Pair 9-
16)
and
Module 3 (Pair 17-24)
to install
additional BRX-PWR-M module(s).
